Datalogic-scanning C-BOX 300 Manual de usuario descargar pdf (Pagina 28)

C-BOX 300/310

POSITION MODE

CFG: When the switch is in this position, the C-BOX 3X0 is in

configuration mode. The communication with the scanner is interrupted

and pins 2 and 3 are no longer dedicated to the scanner auxiliary

interface but to the C-BOX 3X0 configuration (see table below). The

system enters configuration mode and waits to be configured through

WinHost (see WinHost Help On Line).

The C-BOX 310 display visualizes an appropriate message.

Once the C-BOX 3X0 configuration is completed, it is necessary to

replace the switch in the Normal Operation position. At the end of the

reboot phase, the C-BOX 3X0 is ready to function with the new

configuration.

9-pin C-Box 3x0 connector pinout in Configuration mode

Pin Name Function

2 RX C-BOX 3X0 Configuration

3 TX C-BOX 3X0 Configuration

5 SGND Signal Ground

CAUTION

When the C-BOX 3X0 configuration is completed, remember to

replace the Configuration switch in the Normal Operation position.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Sin comentarios

Datalogic-scanning C-BOX 300 Manual de usuario Pagina 28