Datalogic Scanning QuickScan QD2100 Manual de usuario descargar pdf (Pagina 41)

Scanning Features

Product Reference Guide 33

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the

state is entered. The range for this setting is from 1 to 255 seconds in 1-second incre-

ments.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20

= 020, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Scan the barcode: SELECT SCANNING ACTIVE TIME SETTING.

5. Scan the appropriate three digits from the keypad in Appendix E, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Tabl e 4 for some examples of how to set this feature.

Table 4. Scanning Active Time Setting Examples

NOTE

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

1 Desired Setting 1 Second 90 Sec. (1.5 min.) 180 Sec. (3 min.) 255 Seconds (4.25 min.)

2 Pad leading zero(es) 001 090 180 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT SCANNING ACTIVE TIME SETTING

Scan Three Characters From

Appendix E, Keypad

‘0’, ‘0’ and ‘1’ ‘0’, ‘9’ and ‘0’ ‘1’, ‘8’ and ‘0’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 319 320

Sin comentarios

Datalogic Scanning QuickScan QD2100 Manual de usuario Pagina 41