Datalogic Scanning QuickScan QD2100 Manual de usuario descargar pdf (Pagina 231)

Codabar

Product Reference Guide 223

Codabar — cont.

Codabar Set Length 1

This feature specifies one of the barcode lengths for Codabar Length Control. Length 1

is the minimum label length if in

Variable Length Mode, or the first fixed length if in

Fixed Length Mode. Length includes the barcode’s start, stop, check and data characters.

The length must include at least one data character.

The length can be set from 3 to 50 characters.

Follow these instructions to set this feature:

1. Determine the desired character length (from 3 to 50). Pad the number with leading

zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

3. Scan the barcode: SELECT CODABAR LENGTH 1 SETTING.

4. Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent

the length setting which was determined in the steps above. You will hear a two-beep indi-

cation after the last character.

5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 29 for some examples of how to set this feature.

Table 29. Codabar Length 1 Setting Examples

NOTE

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

Desired Setting (and pad with

leading zeroes)

03 Characters 09 Characters 15 Characters 50 Characters

2 Scan ENTER/EXIT PROGRAMMING MODE

3 Scan SELECT CODABAR LENGTH 1 SETTING

Scan Two Characters From

Appendix E, Keypad

‘0’ and ‘3’ ‘0’ and ‘9’ ‘1’ and ‘5’ ‘5’ AND ‘0’

5 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 319 320

Sin comentarios

Datalogic Scanning QuickScan QD2100 Manual de usuario Pagina 231