Datalogic Scanning Connection Box C-BOX 150 Manual de usuario descargar pdf (Pagina 17)

INSTALLATION

C-BOX

GND

USER INTERFACE

GND

V+ (10 - 30 Vdc)

Figure 7 - Power Supply Connections

The power supply must be between 10 and 30 Vdc only.

NOTE

Pin 1 is also electrically connected to pins 3 and 5, just as pin 2 is

electrically connected to pins 4 and 6. This is useful for external

trigger/inputs connections.

NOTE

The C-BOX 150 is protected against polarity reversal. A dedicated red

LED signals this condition until correct polarity is restored.

2.4.2 System Wiring

The connection and wiring procedure for C-BOX 150 is described as follows:

1) Open the C-BOX 150 as described in paragraph 2.2.

2) Verify that the C-BOX 150 power switch is off (see Figure 6).

3) Unscrew the compression connectors and pass all the system cables

through them into the C-BOX 150 housing.

4) To connect the power and input/output signals:

• Prepare the individual wires of the system cables by stripping the

insulation back approximately 1 cm.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Sin comentarios

Datalogic Scanning Connection Box C-BOX 150 Manual de usuario Pagina 17